AMERICAN WELDING SOCIETY (AWS) SENIOR CERTIFIED WELDING INSPECTOR (SCWI)
AWS-SCWI EXAM TIPS
American Welding Society - Senior Certified Welding Inspector (AWS SCWI) is a certification that can be availed after completing two renewals as AWS CWI.
There is no study guide available for the same.
There are 13 documents to be studied for the preparation of AWS SCWI.
AWS SCWI Exam Pattern: The interesting part is that it is a two session open book examination. The books are available at the examination center.
Exam Strategy:
Attend as much questions as you are confident to answer in the first go.
The questions that you don't know should be flag marked. Same time write the question number in a paper with document number as heading.
So in the first try you will do two things. first you will answer the questions that you know and will write down the question numbers that you have to refer with code name as heading. This is to be noted in a paper.
Second take the code which is very easy for you. Open it and try yo answer all the questions that you noted below that code heading in the paper. Strike out the question numbers once it is answered.
Then take the next difficult document and answer those questions by referring the document.
This way you can complete the entire exam.
When referring to the code, don't waste much time searching for an answer. Skip if it is not available in the first try. This you can search after answering all the easiest questions.
There are 3 free downloadable documents in that list. Download it and keep with you for the exam. you can do necessary marking on that for easy referring. You can try to complete the questions from this document in the first try.
Stainless Steel Welding AWS D10.6, the ISO related study material and NDT related study material and WPS and PQR are to be studied with more weightage.
Study tight and all the best for your exams.
Man, i wish I could get some sample questions... Aws scwi exam is like a lucky draw at thia point.
ReplyDeleteSCWI Practice Questions – American Welding part A
Delete1.Q:- While inspecting a weld on a 100mm thick high carbon steel plate with tolerance of +5mm you find the weld is visual acceptable, however the parent material has several arc strikes present adjusted the weld approximately 3mm drop deep, what course of action would you take?
1. None I am only inspecting the weld
2. Recommended that the area be dressed smooth
3. Recommended that the area be dressed smooth followed by MPI
4. High carbon steel is net susceptible to cracking so I would weld over the arc strikes then blend them
2.Q:-In the welding of a butt joint made from one side, which of the following controls the profile of the root bead :
1. Root face.
2. Bevel angle.
3. Root gap.
4. None of the above.
Question 1: Answer Recommended that the area be dressed smooth followed by MPI
DeleteQuestion 2: Root gap (I hope so)