FABRICATED ECCENTRIC REDUCER
Different sizes of eccentric reducers are made as per the requirement.
These reducers are made from pipes. Pipes are marked based on the development drawings (There are some formulas available as easy references) and cut pieces are removed as shown in picture 1.
The balance pieces are taken closer to form longitudinal butt joints by heating and hammering methods. Some specifications do not allow the hammering methods. In that cases screws and jacks are used to make the gaps close to form the butt joint.
Disclaimer: These photos are property of this blog and should not be used without written consent from the author. This blog is meant for educational purpose only. If it is used for any other means without the written consent from the author, the author will not be responsible. Author does not guarantee the accuracy of data used in this blog.All the information, data, photo/image, calculations presented in this blog should be used at the sole risk of the user. The blogger is not liable or responsible in any way for any damage, losses or costs arising from use of the blog for any purpose whatsoever or whosoever it may be.
Comments
Post a Comment